Connect the 5pin serial cable according to the manual of your mainboard.In order to use the Touch Mode on your screen: Z_STEPPER_AUTO_ALIGN (in Configuration_adv.h)Ĭonnecting the TFT to the Mainboard Touch Mode Setup Z_MIN_PROBE_REPEATABILITY_TEST (in Configuration.h) Options to fully support Bed Leveling menu: PARK_HEAD_ON_PAUSE (in Configuration_adv.h)įILAMENT_LOAD_UNLOAD_GCODES (in Configuration_adv.h) Options to support M600 with host & (Un)Load menu:ĪDVANCED_PAUSE_FEATURE (in Configuration_adv.h) SET_PROGRESS_MANUALLY (in Configuration_adv.h) Options to support dialog with host (as pre requisite) HOST_STATUS_NOTIFICATIONS (in Configuration_adv.h) HOST_PROMPT_SUPPORT (in Configuration_adv.h) HOST_ACTION_COMMANDS (in Configuration_adv.h) SERIAL_FLOAT_PRECISION 4 (in Configuration_adv.h) SDCARD_CONNECTION ONBOARD (in Configuration_adv.h)ĮMERGENCY_PARSER (in Configuration_adv.h) LONG_FILENAME_HOST_SUPPORT (in Configuration_adv.h)ĪUTO_REPORT_SD_STATUS (in Configuration_adv.h) Options to support printing from onboard media: REPORT_FAN_CHANGE (in Configuration_adv.h) M115_GEOMETRY_REPORT (in Configuration_adv.h) General options which MUST be always activated:ĪUTO_REPORT_TEMPERATURES (in Configuration_adv.h)ĪUTO_REPORT_POSITION (in Configuration_adv.h)ĮXTENDED_CAPABILITIES_REPORT (in Configuration_adv.h) The following options must be enabled in Marlin firmware. To use all the features and functionalities supported by the TFT, The other currently existing branches develop and release-xx.27 are outdated and MUST NOT be used. IMPORTANT NOTE: The Master branch is currently the ONLY branch in the project to be used. The most recent resources such as precompiled firmwares, themes, configuration and language files.MKS TFT is maintained by open source contributors and BTT does not bear any risk of MKS TFT hardware using this firmware. WARNING: BTT does not officially provide MKS TFT hardware support.
Trying to install the firmware on a TFT which is not supported can harm the hardware. Only the TFTs listed below are currently supported. Show more statistics at the end of the print.Setup of BTT TFT35 E3 V3 with MKS SGEN L Mainboards.